Step-by-step directions for gluing inner corners

When completing, the principal problem can be uneven walls and the resulting folds on the wallpaper. It is also necessary to take into account that as soon as the walls are twisted , the joints of wallpaper canvases can invisibly.

After gluing the last one in front of the interior corner of the fabric must measure the remaining space. It is measured from the border of the glued cloth to the adjacent wall, so the resulting amount is added 10-15 millimeters. When the partitions are extremely curved, the additional figure could be more.

Cut a strip equal to the resultant figure, taking into account the allowance. The surfaces are treated with glue. Based on the kind of coat it may be just the wall or surfaces.

The strip is then glued independently using the cut side into the wallsocket. The wallpaper should go on the other airplane.

In case the glued background is wrinkled, you want to make a few smallish cuts perpendicular to the springs.

Level or slope on the adjacent wall is a perpendicular lineup. The distance from the corner is equal to the width of the preceding cut strip, never such as additions.

The surfaces are smeared with glue, and then the coating is glued to the wall with the flat side to the marked line. The cut goes on the adjoining wall.

Protruding corner should be glued by analogy with the inner, but there are little differences, which also have to be taken into account when working.

Measured the space remaining in the glued wallpaper into the adjacent wall. Add 20-25 millimeters to the got figure.

A section is cut off, taking into account the additional 20-25 millimeters.

Prior to gluing, the surfaces are treated with glue.

The edge has to be glued gidpola.ru to the wallpaper fixed on the wall, your own cut facet“goes“ into the adjacent plane. If necessary, small cuts are created in the area of visiting another wallpaper, smoothed and pushed to the wallsocket.

Draw a vertical strip onto the adjoining wall in a distance of only glued cut strip plus 6-10 millimeters.

After applying the glue, the strip is then placed on the wall using its flat side to the line, moving over the border of the glued strip.

The joints have been smeared with adhesive and ironed with a rollercoaster. After that, the upper layer is trimmed across the ruler and the two layers are joined together.